Panasonic LP-RF Series Setup & Maintenance Manual page 211

ERROR
CODE
The settings for separator height ratio or row
E672
height ratio are too small.
Cannot create bar code due to the invalid
E673 number of characters for EAN/UPC/JAN code or
GS1 DataBar.
E674 The string containing "%" is not properly set.
The string No. specified by the SIN command is
E678 not acceptable because the No. has not been set
in Laser Marker NAVI smart.
Communication was interrupted. The adjustment
E679 *2, *3 value of power optimization by marking position
could not apply to the laser marker.
Any of the following functions that are not
available with the RUN mode ON are configured.
• Registered characters via I/O
E680
• External offset (via I/O and SEO command)
• Characters specified by SIN command
• Link control with external image checkers
Any of the following functions that are not
available with on-the-fly marking are configured.
• Link control with external image checkers
• Overwriting interval
• Skip marking of 2D code (module marking
order)
E682 *3, *4 When the trigger mode is set to Marking at
regular intervals or Multiple triggers, those
functions are also not available.
• Registered characters via I/O
• External offset (via I/O and SEO command)
• Characters specified by SIN command
• Counter reset at date change
Description
ME-LPRF-SM-11
Measures *1
• Correct the separator height ratio or the barcode
height ratio so that the height is larger than the "line
width (calculation value)" specified in the object
group settings.
• If you want to remove the separator, set 0 to the
separator height ratio.
Enter the prescribed number of characters according
to the code type.
• If the functional characters such as a counter and
date/time are input, delete and re-enter characters
after "%".
• To enter "%" as a character to mark, enter "%%".
• To enter "+" or "/" as a character to mark after the
counter, enter "%+" or "%/".
Specify the same No. set in "characters specified by
SIN command" setting in Laser Marker NAVI smart
to the string No. in SIN command data.
• Set the adjustment value of power optimization by
marking position and apply it to the laser marker
again.
• Do not turn off the power during the application
processing.
• Do not turn on the remote mode during the
application processing.
• To execute marking in the RUN mode, delete
these functions from the marking data.
• When you use these functions, control the laser
marker in the remote mode.
• To use on-the-fly marking, delete these functions
from the marking file.
• Some functions are available when Trigger mode
of the on-the-fly settings is set to Single trigger.
211