Panasonic LP-RF Series Setup & Maintenance Manual page 68

„ Setting procedure for Ethernet online connection
For communication between the laser marker and PC terminal using Ethernet, you need to configure the following
communication settings first.
1.
Connect Laser Marker NAVI smart and laser marker to online via a USB cable.
2.
Go to the "System settings" screen and select
"Communication" tab.
Input the Ethernet settings according to the
network settings.
Set a separate IP address not to overlap between
the laser marker and PC on the network.
3.
Select "Apply to laser marking system" on the left side of the ribbon.
4.
Select the "Connection" tool in the ribbon.
5.
In the "Connection" dialog, select "Disconnect".
The online connection with the laser marking
system is now disconnected.
6.
Turn off the power of the laser marking system,
wait five seconds and then restart the system.
7.
On the "Startup" screen, select "Online" to open
the "Connection" dialog.
8.
To use the Ethernet connection, select "Including
Ethernet connections", and then select "Search
laser marker".
Check that an Ethernet connection appears in the
list.
9.
Select the laser marking system that you want to
connect and select "Connect". When the online connection is established, the "Marking settings" screen appears.
68
ME-LPRF-SM-11
"Apply to laser marking
system" tool