Restore Of Circuit Protector - Panasonic LP-RF Series Setup & Maintenance Manual

2-5-3 Restore of circuit protector

The circuit protector is mounted in the controller for the overcurrent protection.
In case of the overcurrent, it turns OFF to cutoff current.
To recover the power supply of the laser marker, turn ON the switch of the circuit protector with the following procedures.
1.
Remove causes of the overcurrent.
2.
Turn OFF the key switch of the controller, and disconnect the AC power cable.
3.
Remove the front cover of the controller.
Apply pressure to the tabs on the top of the cover and pull it open.
Controller
4.
Turn on the switch of the circuit protector.
Side of circuit protector
5.
Attach the front cover of the controller.
Insert the lower part of the cover to the controller and gently push the upper part until it clicks into place.
6.
Connect the AC power cable and turn on the key switch. Confirm the laser marker starts up normally.
Tab
ON
OFF
Switch
ME-LPRF-SM-11
Switch
OFF
ON
Cover
53