Panasonic LP-RF Series Setup & Maintenance Manual page 74

„ RUN mode procedure
In RUN mode, either a signal from Laser Marker NAVI smart or from an external device starts the laser radiation.
1.
Establish an online connection between your PC and the laser marking system.
2.
Select "Laser pumping" in the ribbon to turn on the laser pumping.
3.
Select "Operation" in the ribbon and select "RUN ON".
4.
When you turn ON the RUN mode, the laser marker enters into
the marking start signal standby state.
Enter the marking start signal (marking trigger) in any of the
following methods to irradiate the laser beam.
• Switches or sensors connected to TRIGGER IN (X5) on the I/O
terminal block
• "Start marking" button in Laser Marker NAVI smart
"Start marking" button
74
ME-LPRF-SM-11
"Laser pumping" tool
ON status OFF status
"Operation" tool
Remote mode OFF/
RUN mode OFF
Switch for
marking trigger