Panasonic LP-RF Series Setup & Maintenance Manual page 48

„ Installing connector cover to cable
To ensure the ingress protection (IP64) of the head, install the attached connector cover to the unit power cable and signal
cable.
• If there are signs of deterioration or damage in the gaskets of the connector covers, replace them. Replacement
connector covers and gasket (LP-ACC10) are available on request. For purchasing them, contact our sales agency.
1.
Confirm that the all parts for the connector covers are in the package as shown below.
q
Connector cover for unit power cable
No. Part name
Upper cover
q
Bottom cover
w
2.
Pass the cable through the hole of the bottom cover and connect it to the head.
Connect the unit power cable to POWER connector on the head and the signal cable to SIGNAL connector
respectively.
• First, connect the unit power cable and set the connector cover to it. Then, connect the signal cable.
Rear of head
3.
Tighten the fixing screw of the cable connector and then slide the bottom cover to the head.
48
w
Unit power cable
w
q
Connector cover for signal cable
Rear of head
ME-LPRF-SM-11
Signal cable