Connecting Laser Marker; Connection Of Head And Controller - Panasonic LP-RF Series Setup & Maintenance Manual

2-5 Connecting Laser Marker

WARNING

2-5-1 Connection of head and controller

• It is recommended to connect the head and controller that have the identical serial numbers.
• For the connection of this product, use the dedicated cables attached to the product or the specified optional cables.
• Insert the cable all the way in a straight line. Tilting and inserting the cable may cause a failure.
• Be careful not to apply excess force to the cable or not to nip the cable at the installation.
• Verify the minimum bend radius of each cable and install them without excess forces being applied.
• To ensure the ingress protection (IP64) of the head, install the attached connector covers to the cables.
Rear of head
No. Cable and connector
Signal cable
q
Unit power cable
w
Connector cover
e
I/O terminal block
r
• Connect the following terminals of the I/O terminal block. If any of them is not connected, the laser radiation is disabled.
When shipped, some of these terminals are connected with a shot bar. Refer to "4-5-1 Factory default wiring" (P.101).
LASER STOP IN (X10)
LASER STOP IN (X11)
INTERLOCK 1(+) (X16)
INTERLOCK 2(+) (X18)
REMOTE INTERLOCK (X20)
IN COM. 1 (X2)
OUT COM. 1 (Y2)
*1 : Connect IN COM. 1 (X2) and OUT COM. 1 (Y2) respectively to the power supply for input and output. Refer to "4-5-2
Connecting common terminals" (P.102).
• Be sure to turn the power off before you conduct wiring or connection. Failure
to do so may cause electrical shock.
• Be sure to connect the head and controller of the laser marker which have the
same model number. Otherwise there is a risk of exposure to laser radiation
or failure.
e
e
Connector
Signal connector: SIGNAL
Power connector: POWER
Signal cable / Unit power cable (head side)
I/O terminal block connector: TERMINAL
― OUT COM. 1 (X12)
― OUT COM. 1 (X12)
― INTERLOCK 1(-) (X17)
― INTERLOCK 2(-) (X19)
― OUT COM. 1 (X12)
― Power supply *1
― Power supply *1
ME-LPRF-SM-11
w
q
r
Rear of controller
47