Panasonic LP-RF Series Setup & Maintenance Manual page 94

No. Name and description
Data number to switch when using the registered characters/external offset function (SELECT 0 IN: ON)
t
The registered characters/external offset function is a function that switches marking characters (registered
characters) or the position (external offset) using the input terminal D0 to D15. Configure the character or
coordinate patterns to the data number corresponding to D0 to D15 in advance. Specify which pattern you
will mark from D0 to D15.
Specify the data number in the binary system as D0 to D15 and turn ON SET IN (No.2).
The data numbers corresponding to D0 to D15 are defined as follows according to the settings.
I/O input condition settings *
Registered characters: 4-bit × 4
Registered characters: 8-bit × 2
External offset: Lower 4 bits
External offset: Lower 8 bits
External offset: Lower 10 bits
* You can also use the registered characters via I/O together with the external offset function. If you use
the same terminal for both the registered characters and external offset at this time, the input status will
be reflected to the data number of both functions.
Example: Specify data number 15 when using lower 8 bits
Select "0000 1111", which represents 15 in a 8-bit binary system, by specifying ON/OFF of D0 to D7 as
shown in the below table. (D0 is the lowest digit number.)
D0 to D7: Data number of registered characters/external offset (the lower 8 bits are used)
Terminal
D0
D1
D2
D3
D4
D5
D6
D7
94
Terminal
D0 to D3
D4 to D7
D8 to D11
D12 to D15
D0 to D7
D8 to D15
D0 to D3
D0 to D7
D0 to D9
Data number (binary)
1
1
1
1
0
0
0
0
ME-LPRF-SM-11
Data number target
Registered character table 0
Registered character table 1
Registered character table 2
Registered character table 3
Registered character table 0
Registered character table 1
External offset
External offset
External offset
Input
ON
ON
ON
ON
OFF
OFF
OFF
OFF
Data number
0 to 15
0 to 15
0 to 15
0 to 15
0 to 255
0 to 255
0 to 15
0 to 255
0 to 1023