Huawei NetCol8000-C070 User Manual page 113

NetCol8000-C(070, 130, 190) In-room Chilled Water
Smart Cooling Product
User Manual
Menu
T/H Sensor
Comm
Settings
Issue 09 (2022-12-15)
Parameter
In-cabinet water
overflow alarm
action
Temperature and
humidity control
type
Temperature
setpoint
Humidity setpoint
Modbus Comm
address
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Power-On Commissioning
Description
Set the action of the device if there is water
overflow in the cabinet based on the actual
scenario.
● Shutdown: The device shuts down when
an in-cabinet water overflow alarm is
generated.
● Inactivity: The device runs as usual when
an in-cabinet water overflow alarm is
generated.
● Only indoor fan running: Only the indoor
fan runs when an in-cabinet water
overflow alarm is generated.
● Humidifier stopped: Only the humidifier
is stopped when an in-cabinet water
overflow alarm is generated.
When the application scenario is non-aisle
containment, you are advised to choose
Return air. Choose Cold aisle if cold aisle
T/H sensors are installed. Hot aisle is not
recommended.
After the temperature and humidity control
type and the temperature value under this
type are set, the device performs regulation
based on the settings.
● Return air: The value ranges from 18°C
to 45°C.
● Supply air: The value ranges from 15°C
to 35°C.
● Cold aisle: The value ranges from 15°C to
35°C.
● Hot aisle: The value ranges from 18°C to
45°C.
After the temperature and humidity control
type and the humidity value under this type
are set, the device performs regulation
based on the settings.
40%–60% is recommended.
Enter the communication address planned
for the smart cooling product. The
management system communicates with
the smart cooling product through this
address. The communication addresses of
the two smart cooling products connected
to the same management system must be
different.
103