Startup - Huawei NetCol8000-C070 User Manual

NetCol8000-C(070, 130, 190) In-room Chilled Water
Smart Cooling Product
User Manual
Parameters of System Control
●
●
●
●
●

4.6 Startup

Context
On the home screen of the display module, there are Start and Shutdown
buttons for controlling the startup and shutdown of the unit.
●
●
●
●
Initial Startup
After factory settings are restored, startup verification is required.
Step 1 Tap Start on the home screen to enter the initial startup screen. Tap OK to enter
the startup authorization screen.
Issue 09 (2022-12-15)
Cooling start temperature demand > Cooling stop temperature demand
Lower limit for dehumid start temperature demand > Lower limit for dehumid
close temperature demand
Upper limit for dehumid start temperature demand > Upper limit for dehumid
close temperature demand
Temperature demand for dehumidifying heating close > Dehumid heating
start temp demand
Low-temp heating close temp demand > Low-temp heating start temp
demand
If the unit is powered on again after a power failure, the unit automatically
restores to the original startup/shutdown state before the power failure.
Hardware ports are reserved on the display module to control the status of
remote dry contacts or remote startup and shutdown signals. The status of
remote dry contacts and remote startup and shutdown signals is started by
default.
A unit can be started over the screen or NMS only when the status of remote
dry contacts or remote start/shutdown signal is Start.
If you choose Settings > System Settings > System Control and set
Password required for start or shutdown onsite to Yes, a password is
required for startup or shutdown. If you set Password required for start or
shutdown onsite to No, no password is required for startup or shutdown.
NO TICE
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Power-On Commissioning
125