Setting Communications Parameters (Snmp Protocol) - Huawei NetCol8000-C070 User Manual

NetCol8000-C(070, 130, 190) In-room Chilled Water
Smart Cooling Product
User Manual
Parameter
Pre-shared
password
----End

4.5.4.4 Setting Communications Parameters (SNMP Protocol)

Context
●
●
●
●
Procedure
Step 1 On the home screen, choose Settings > Comm Settings > SNMP Settings. The
screen shown in
Figure 4-10 Setting SNMP communications parameters
Step 2 Set SNMP Version based on site requirements, and then tap Submit.
●
●
Step 3 Set Read Community and Write Community.
1.
Issue 09 (2022-12-15)
Setting
-
To set communications parameters, log in as the admin user.
This section is suitable only for SNMP. Skip this section if you use Modbus.
Record the values entered in this section which will be needed when you
access a smart cooling product to an NMS.
One smart cooling product supports concurrent access of up to 6 EMSs
through SNMP.
Figure 4-10
When SNMP Version is set to ALL or SNMPv1&v2c, you can set Read
Community and Write Community by referring to
When SNMP Version is set to ALL or SNMPv3, you can add an SNMPv3 user
by referring to Step 4.
CA UTION
SNMPv1&SNMPv2c are insecure protocols. SNMPv3 is recommended.
Tap the text box next to Read Community, set the read community
parameter based on the actual plan, tap
Copyright © Huawei Digital Power Technologies Co., Ltd.
Setting Method
Secondary authentication password used for
Modbus-TCP connection.
is displayed.
, and tap Submit.
4 Power-On Commissioning
Step 3.
120