GE Voluson S6 Basic User Manual page 208

Hide thumbs Also See for Voluson S6:

Doppler Modes

8.7.2 Artifact Suppression

8.7.3 Audio Signal

8.7.4 Balance

Adjusting the angle is always possible, in scan mode and freeze mode.

Artefact suppression reduces of movement artefacts in the image. For cardiac application it is

recommended to switch off the artefact suppression.

Switch on/off the artefact suppression in the Map section of the Submenu.

The control button below the right hand side probe holder changes the volume of the audio

signal derived from the spectrum.

Turn clockwise: both loudspeakers louder Turn counterclockwise: both loudspeakers lower

The volume is adjustable between 0 and 96 dB.

"Balance" control establishes the amount of Color displayed over bright echoes and helps

confine Color within the vessel walls. Raising this balance displays Color on brighter

structures. If you see Color on vessel walls, the balance is probably set too high. Additionally,

wall motion ghosting can be suppressed with a low balance setting.

Select [-] or [+] on the [Balance] key and select the balance range.

The Balance orientation line (1) is only visible in the color modes. The line represents the

position of the adjusted displayed gray value in the gray wedge.

Voluson® S6/S8 Basic User Manual

5433669-100 Revision 4

Show Quick Links

Chapters