GE Voluson S6 Basic User Manual page 459

11.2.6.2 Before starting Urology Calculations
Note
11.2.6.3 Urology Calculations in 2D Mode
11.2.6.4 Urology Calculations in M Mode
11.2.6.5 Urology Calculations in Spectral-Doppler Mode
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
1. Press the [Patient] key on the control panel, select the [URO] page and enter all patient
information for Urology calculations. For details refer to: Entering Patient Data
on page 4-10 )
'Entering Patient Data'
To cancel all calculations performed before and to start new measurement, press this key and
select [End Exam] or [Clear Exam].
2. Press [Start Exam].
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe] key on the control panel, and change it to Urology. For details refer
to: Probe/Program Selection
•
Distance Measurements (like Length, Height, etc.)
•
Vessel Area/Vessel Diameter
•
Stenosis Area/Stenosis Diameter
The measurement procedures in 2D Mode are the same than in application "Abdomen".
review: Abdomen Calculations in 2D Mode in 'Abdomen Calculations'
•
Vessel Diameter
•
Stenosis Diameter
•
Time
•
HR (Heart Rate)
The measurement procedures in M Mode are the same than in application "Abdomen". review:
Abdomen Calculations in M Mode in 'Abdomen Calculations'
•
Auto Trace
Measurements and Patient Worksheets (Reports)
(chapter 'Probe/Program Selection' on page 4-7 )
(chapter
on page 11-24 .
on page 11-24 .
11-83