GE Voluson S6 Basic User Manual page 341

Hide thumbs Also See for Voluson S6:

9.12.4.2 Automatic - Sphere

Voluson® S6/S8 Basic User Manual

5433669-100 Revision 4

4. Select the next image plane by means of this control below the menu area,

or select the [Next] key.

The contour is copied to the next image plane and can be redefined by

drawing a new contour. Every time you start to outline a contour, the new

contour in this image plane replaces the old one.

5. Trace all remaining contours in the same manner.

6. After you have defined the contours in all image planes, select the [Done]

key. The result is displayed on the monitor and the VOCAL Edit menu

appears on the menu area. To edit the contour review: VOCAL - Edit

'VOCAL - Edit'

This computer assisted contour mode function is only useful if you want to outline the surface

of a sphere. Using this function a sphere round the main contour axis is generated within the

two green arrows. For details review: VOCAL Settings

1. In the "VOCAL Modes" menu, select the [Sphere] contour mode key.

Adjust the upper contour point (characterized by a green arrow) by using this control below the

Adjust the lower contour point (characterized by a green arrow) by using this control below the

Two contour points are marked in the image plane(s) along the main contour axis to define the

poles of the (shell) contour. (All generated contours in the image planes cross the main

contour axis at these two points.)

4. To start defining the contour, select the [Start] key. The result is displayed

on the monitor.

on page 9-124 ).

(chapter 'VOCAL Settings' on page 9-

Show Quick Links

Chapters