GE Voluson S6 Basic User Manual page 86

Operating the System
4.8.6 To Search in the Patient List
Note
4-26
Highlight an entry from this list using the trackball and press the central trackball button.
Detailed DICOM information is displayed.
The status of a step can be none (not started), in progress, completed or discontinued.
Select this button to complete the step by sending a MPPS complete message (only possible if
status of step is "in progress").
Select this button to cancel a step by sending a MPPS discontinue message (only possible if
status of step is "in progress").
Select this button to start the procedure not immediately, but only after pressing "Start Exam"
in the patient dialog (only possible if no other step is "in progress" and status of step is not
started).
Select this button to start exam immediately without returning to the Patient dialog (only
possible if no other step is "in progress" and status of the step is not started.
Select this button to return to worklist dialog or to the patient menu (depending on where the
procedure step was started from).
Click the [Exit] button on the menu area.
Exit from the Worklist search screen. No result will be copied.
Please note:
The [Worklist] button can only be selected if a "Service: WORKLIST" DICOM address is
specified in the System Setup. To specify a DICOM Address: 'Connectivity'
Select the [Search] button using the trackball cursor and enter with the left or right trackball
key.
In System Setup - General - Patient Info Display there is a checkbox "Automatically List
Patients" . If this checkbox is marked, all exams will be displayed automatically upon pressing
search. If this checkbox is unmarked no exams will be displayed when you press [Search] until
you click the [Show All] button on the screen.
This button is available on the "Patient Information" screen
page 4-13 ) .
on page 13-30 )
( '"Patient Information" screen' on
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4