GE Voluson S6 Basic User Manual page 437

Note
11.2.5.3 Cardiology Calculations in 2D Mode
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
1. Press the [Patient] key on the control panel, select the [CARD] page and enter all patient
information for Cardio calculations. For details refer to: Entering Patient Data
on page 4-10 )
'Entering Patient Data'
To cancel all calculations performed before and to start new measurement, press this key and
select [End Exam] or [Clear Exam].
2. Select [Start Exam].
2. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe] key on the control panel, and change it to Cardiology. For details
refer to: Probe/Program Selection
•
(chapter 'LV Simpson' on page 11-62 )
LV Simpson
•
Vol A/L (Volume Area/Length)
•
(chapter 'LV (Left Ventricle)' on page 11-64 )
LV (Left Ventricle)
•
(chapter 'LV Mass' on page 11-64 )
LV Mass
•
LVOT- or RVOT Diameter
•
(charter 'MV (Mitral Valve)' on page 11-67 )
MV (Mitral Valve)
•
TV (Tricuspid Valve)
•
AV/LA (Aortic Valve/Left Atrium)
68 )
•
PV (Pulmonary Valve)
Measurements and Patient Worksheets (Reports)
(chapter 'Probe/Program Selection' on page 4-7 )
(chapter 'Vol A/L (Volume Area/Length)' on page 11-62 )
(chapter 'LVOT- or RVOT Diameter' on page 11-65 )
(chapter 'TV (Tricuspid Valve)' on page 11-67 )
(charter 'AV/LA (Aortic Valve/Left Atrium)' on page 11-
(charter 'PV (Pulmonary Valve)' on page 11-68 )
(chapter
11-61