GE Voluson S6 Basic User Manual page 425

11.2.4.16 Obstetric Calculations in 2D Mode
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
If a Fetus number has been entered, several fetuses can be measured on one patient.
Select this flipswitch to change from fetus A to B or C or fetus D.
2. Press the [GA] key on the menu area to enter the Gestational Age. Alternatively the GA can
be calculated by entering the LMP the DOC or the EDD. For details refer to: Entering Patient
(chapter '"Patient Information" screen' on page 4-13 )
Data
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe] key on the control panel, and change it to Obstetric. For details
refer to: Probe/Program Selection
•
Distance Measurements
valve, Ascending Aorta, etc.)
•
Area Measurements (see, '2D Mode Measurements'
Area)
Measurements and Patient Worksheets (Reports)
(chapter 'Probe/Program Selection' on page 4-7 )
(chapter 'Distance Measurements' on page 11-50 ) (like Aortic
on page 11-5 ) (like RV Area, LV
11-49