Advertisement
Measurements and Patient Worksheets (Reports)
11.1.2.4.2 Angle 2 Line
Note
11.1.3 M-Mode Measurements
11-14
Remark: The angle between the two lines is displayed.
1.
To measure the angle between to lines, select the [Angle 2 Line] item in the menu area.
A cursor appears on the screen.
2.
Move the cursor to the start point of the angle measurement and press the right or left
trackball key [Set] to fix the marker. A horizontal line appears.
3.
By means of the trackball, rotate the line to adjust the angle and then press [Set] again.
To re-adjust the start point, press the upper trackball key [Change] before completing the
measurement. This alternates the control from one cursor to the other.
•
For details about adjusting M Mode measurement settings, review: Measure Setup -
(chapter 'The Measure Setup Pages' on page 11-109 )
Measure & Calc
•
The "Factory" Generic Sub Category for M-Mode (see image above) supports 1 Study
type and following Measure methods:
Study
(chapter
'Generic
Measurements'
on page 11-
15 )
Measure
Distance 2 Points
(chapter 'Distance
on page 11-15 ) Slope
2 Points'
(chapter 'Slope' on page 11-15 )
(chapter 'Time' on page 11-
Time
15 ) Stenosis %Distance (chapter
on page 11-
'Stenosis %Distance'
16 ) HR (Heart Rate) (chapter 'HR
(Heart Rate)'
on page 11-16 )
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
Hide quick links:
Advertisement
Chapters
