GE Voluson S6 Basic User Manual page 415

11.2.4.3 Obstetric Calculations in 2D Mode
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
If a Fetus number has been entered, several fetuses can be measured on one patient.
Select this flip switch control to change from fetus A to B or C or fetus D.
2. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe] key on the control panel, and change it to Obstetric. For details
refer to: Probe/Program Selection
•
Distance Measurements
FL, etc.)
•
Circumference Measurements
42 ) (like HC, AC, etc.)
•
(chapter 'AFI Calculation' on page 11-43 )
AFI Calculation
Measurements and Patient Worksheets (Reports)
(chapter 'Probe/Program Selection' on page 4-7 )
(chapter 'Distance Measurements' on page 11-40 ) (like BPD,
(chapter 'Circumference Measurements' on page 11-
11-39