GE Voluson S6 Basic User Manual page 389

11.1.2.4 Generic Angle Measurement
11.1.2.4.1 Angle 3 Point
Note
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
•
The different sections can be chosen liberally, it is not necessary to follow a certain
order.
•
The volume measurement is only possible in 3D static mode 3D static mode will be
activated automatically when switching on the measurement. Full size format active: A
render image will be replaced by the current reference section plane image during the
3D Multiplane measurement and is shown again when you exit the 3D Multiplane
measurement.
•
To erase the results, select the [Init] key on the menu area.
1. To measure the angle by setting 3 points, select the [Angle 3 Point] item in the menu
area. A cursor appears on the screen.
2. Move the cursor to the start point of the angle measurement and press the right or left
trackball key [Set] to fix the marker. A second cursor appears.
3. Move this cursor to the second point of the measurement and press [Set] again.
To re-adjust the start point, press the upper trackball key [Change] before completing the each
distance measurement. This alternates the control from one cursor to the other.
4. Move the third cursor to the end point of the angle measurement.
Measurements and Patient Worksheets (Reports)
11-13