Siemens SINAMICS S120 Function Manual page 540

Appendix
A.2 Availability of SW functions
No.
9 Edge modulation (higher output voltages) in the vector
control type, also with booksize devices
10 DC braking
11 Armature short-circuit: Internal
12 Armature short-circuit: Intermittent voltage protection
13 Automatic firmware update for DRIVE-CLiQ components
14 Save STARTER project direct to CF card
15 The terminal area for booksize infeeds (BLM, SLM, ALM)
can be parameterized to 230 V 3 AC
16 Automatic speed controller setting
17 Technological pump functions
18 Simultaneous cyclical operation of PROFIBUS and
PROFINET on CU320
19 Automatic restart also with servo
20 Operates at 500 μs PROFINET I/O
21 Absolute position information (X_IST2) with resolver
22 DC link voltage monitoring depending on the line voltage
23 Automatic line frequency detection
24 Acceleration signal at the ramp function generator output
25 Reset the drive device via parameter (p0972)
26 Alteration of the basic sampling time during the automatic
readjustment of the sampling times depending on the
number of drives on CU320 with vector (from 400 µs to
500 µs)
27 Dynamic energy management, extension of the Vdc_min,
Vdc_max control
28 Endless trace
29 Extended PROFIBUS monitoring with timer and binector
30 Indexed actual value acquisition
Simultaneous evaluation of multiple encoders
540
SW function available Servo
since FW
2.5 -
2.5 SP1 x
2.5 SP1 x
2.5 x
2.5 x
2.5 x
2.5 SP1 x
2.5 x
2.5 -
2.5 SP1 x
2.5 SP1 x
2.5 SP1 x
2.5 x
2.5 x
2.5 x
2.5 x
2.5 x
2.5 -
2.5 x
2.5 x
2.5 x
2.5 SP1 x
Function Manual, (FH1), 07/2007 Edition, 6SL3097-2AB00-0BP4
Vector HW component
x only for DAC Motor
Modules
(6SL3xxx-xxxxx-
0AA3)
x
x
- only for DAC Motor
Modules
(6SL3xxx-xxxxx-
0AA3)
x
x
x only for booksize
DAC infeeds
(6SL3xxx-xxxxx-
0AA3)
since
FW2.1
x
x
since
FW2.2
-
x
x
x
x
x
x
x
x
x
x
Drive Functions