Huawei V100R001 User Manual page 20

HUAWEI TE30 Videoconferencing Endpoint
User Guide
Parameter
PPPoE
Dialing
mode
Connection
type
Local IP
address
Subnet mask
Issue 01 (2013-03-27)
Description
transmission rate is 100 Mbit/s, and
data can be sent and received at the
same time.
Specifies whether your TE30 accesses
broadband networks using dial-up
connections.
NOTE
If you set this parameter to Enable, you must
also set Dialing mode, User name, and
Password.
Specifies the dial-up connection mode.
The dial-up process complies with the
Point-to-Point Protocol over Ethernet
(PPPoE) protocol. To use a dial-up
connection, in User name and
Password, enter the user name and
password that are provided by your
broadband access service provider.

Auto: When your TE30 starts, it
automatically sets up a dial-up
connection over the IP network. If the
dial-up service is not free of charge,
charging starts when the dial-up
connection is established.
 Manual: Your TE30 uses the dial-up
program to access the network.
Choose Advanced Settings >
Utilities > PPPoE Dialing >
Connect and set up a PPPoE dial-up
connection.
Specifies the mode for your TE30 to
obtain an IP address.
 Static IP: The network administrator
assigns an IP address to your TE30. If
you select this option, you must also
set Local IP address, Subnet mask,
and Gateway address.
 Dynamic IP: When a DHCP server is
available on the network, your TE30
automatically obtains an IP address
using the Dynamic Host
Configuration Protocol (DHCP).
Specifies the IP address and subnet mask
of your TE30.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Network
Setting
The default value is Disable.
The default value is Auto.
The default value is Static IP.
If you have set NMS server,
select Static IP for this
parameter.
Contact the network
administrator.
Examples:

IPv4 address: 192.168.1.10
 IPv6 address:
2000:0:0:0:200:55:26:1
12