Huawei V100R001 User Manual page 61

HUAWEI TE30 Videoconferencing Endpoint
User Guide
Parameter
Type
Number
IP address
Rate
URI
Country/Region
code
Issue 01 (2013-03-27)
Description
Specifies the line used for the site
to access the videoconferencing
network.

If you select IP, your TE30 will
use the protocol set for
Preferred IP protocol to call
the site.
 If you set Category to CT site,
the available value for this
parameter is SIP.
Specifies the site number used to
place calls between sites.
 The IP, E1, T1, 4E1, basic rate
interface (BRI), and H.323
phone site numbers are
allocated by the
videoconferencing service
provider.

The PSTN site numbers are
telephone numbers.
Specifies the IP address of the site.
NOTE
This parameter is unavailable if you
set Category to IP address.
Specifies the call rate of the line
selected for the remote endpoint.
The call rates supported vary
depending on the type of the site
you want to call.
Specifies the uniform resource
identifier (URI) of the site, for
example, abcd@huawei.com.
NOTE
This parameter is available only when
Type is set to IP, H.323, or SIP.
Specifies the country or area where
your TE30 is located.
This parameter is required when
Type is set to ISDN or PSTN.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Conference
Setting
 Telepresence site: Select
this option for a Huawei
telepresence site.
 CT site: Select this option
for a Cisco TelePresence
site.
The default value is H.323.
No default value is set for this
parameter.
No default value is set for this
parameter.
The default value is 8Mbps.
Select the highest available
call rate.
No default value is set for this
parameter.
No default value is set for this
parameter.
53