Huawei V100R001 User Manual page 50

HUAWEI TE30 Videoconferencing Endpoint
User Guide
Parameter
Call times
Default call
bandwidth
Step 2 Select Save.
----End
Setting Advanced Conference Parameters
Step 1 Choose Advanced Settings > Settings > Conference > Advanced. Set the advanced
conference parameters by referring to
Table 6-2 Advanced conference parameters
Parameter
Audio protocol
Audio and
video protocols
Video protocol
Issue 01 (2013-03-27)
Description
when Wi-Fi is enabled. For details,
see 3.4 Setting Wi-Fi
Specifies the maximum number of
attempts your TE30 calls a
specified site after startup.
Specifies the default data
transmission rate for your TE30.
NOTE
If this parameter is set incorrectly, the
video quality will be affected, or the
call might even fail to be set up.
Table
Description
Specifies the audio protocol the
TE30 uses to encode audio.
Specifies the audio and video
protocol capability of your TE30.
Using the audio or video protocol
that you select, your TE30
negotiates the audio or video
capability with a remote endpoint
to set up a call.
If you do not select a audio or
video protocol under Audio and
Video Protocols, you cannot
select that protocol for Video
protocol, H.239 video protocol,
or Audio protocol.
Specifies the video protocol the
TE30 uses to encode video.
During a non-multi-stream
conference, the video protocol is
the video protocol the TE30 uses
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Setting
Parameters.
The default value is 1.
The maximum value is 10.
If you set this parameter to 0, your
TE30 does not call the specified
site after startup.
The default value is 1920kbps.
6-2.
Setting
The default value is Auto.
All protocols are selected by
default.
The default value is Auto.
6 Conference
42