Huawei V100R001 User Manual page 29

HUAWEI TE30 Videoconferencing Endpoint
User Guide
Parameter
IP priority
Service type
DSCP audio
DSCP video
DSCP data
DSCP
signaling
Network
jitter
Lip sync.
Step 2 Select Save.
----End
Issue 01 (2013-03-27)
Description
 DiffServ: If you select this option,
you must also set DSCP. DSCP
stands for Differentiated Services
Code Point.
Specifies the priority that a network
device gives to forwarding the data
packets sent by your TE30. A larger
value indicates a higher priority.
Specifies how the data packets sent and
received by your TE30 are processed on
the network. Five values are available:
 Normal: The network devices
transmit the data packets without
special processing.
 Minimum delay: The data packets
are transmitted at the highest rate
with the minimum delay.
 Maximum throughput: A large
number of data packets can be
transmitted on the network.

Highest reliability: The data packets
can be transmitted to remote sites
completely and correctly.

Minimum cost: The network devices
transmit data packets of the same
traffic at lower costs.
Specifies the service level of data
packets sent by your TE30 during
transmission.
A larger value indicates a higher service
level.
Adjusts network jitter settings to address:

Lip synchronization problems during
conferences
 Choppy audio problems, by
increasing the network jitter value.
Fine-tunes network jitter settings if a
slight lip synchronization problem
persists after the network jitter settings
are adjusted.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Network
Setting
Value range: 0-7
The default value is 7.
The default value is Minimum
delay.
Value range: 0-63
The default value is 63.
Value range: 0 ms to 1000 ms
The default value is 0ms.
Value range: 0 ms to 300 ms
The default value is 0ms.
21