Configuring The Ntp Server; Setting The Sleep And Wakeup Mode - Huawei V100R001 User Manual

HUAWEI TE30 Videoconferencing Endpoint
User Guide
----End

13.4 Configuring the NTP server.

The Network Time Protocol (NTP) server is used for system synchronization and provide
time accuracy.
Procedure
Step 1 Choose Advanced Settings > Settings > General > Date and time. Set the NTP parameters
by referring to
Step 2 Select Save.
----End

13.5 Setting the Sleep and Wakeup Mode

Your TE30 supports the sleep mode. You can set the sleep time, automatic startup, and
automatic shutdown time.
To reduce power consumption, you can configure your TE30 to enter sleep mode after it has
been in the idle state for a defined period of time.
Procedure
Step 1 Choose Advanced Settings > Settings > General > Power supply. Set the sleep and
automatic startup and shutdown parameters by referring to
Table 13-4 Sleep and automatic startup and shutdown parameters
Parameter
Enter sleep mode
Wake-on-LAN
Issue 01 (2013-03-27)

To view the serial number of your TE30, choose Advanced Settings > Diagnostics > System
Information > Version.

Press and hold the MODE button for 10 seconds or more, and the TE30 will be restored to its default
settings and restart. After the endpoint is restored to its default settings, its IP address is reset to
192.168.1.1.
Table 2-4.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Specifies the period after
which the TE30 enters sleep
mode if you do not perform
any operations.
If you set this parameter to
Never, the TE30 will never
enter sleep mode.
Specifies whether you can
use an encapsulation tool to
remotely power on or wake
the TE30.
13 Maintenance
Table 13-4.
Setting
The default value is After
10 min.
The default value is
Disable.
113