Hitachi SH7750 Hardware Manual page 726

SCFCR2 performs data count resetting and trigger data number setting for the transmit and receive
FIFO registers, and also contains a loopback test enable bit.
SCFCR2 can be read or written to by the CPU at all times.
SCFCR2 is initialized to H'0000 by a power-on reset or manual reset. It is not initialized in
standby mode or in the module standby state.
Bits 15 to 11—Reserved: These bits are always read as 0, and should only be written with 0.
Bits 10 to 8 (SH7750)—Reserved: These bits are always read as 0, and should only be written
with 0.
Bits 10 to 8 (SH7750S, SH7750R)—RTS2
RSTG0): These bits output the high level to the RTS2 signal when the number of received data
stored in the receive FIFO data register (SCFRDR2) exceeds the trigger number, as shown in the
table below.
Bit 10: RSTRG2 Bit 9: RSTRG1
0 0
1
1 0
1
Bits 7 and 6—Receive FIFO Data Number Trigger (RTRG1, RTRG0): These bits are used to
set the number of receive data bytes that sets the receive data full (RDF) flag in the serial status
register (SCFSR2).
The RDF flag is set when the number of receive data bytes in SCFRDR2 is equal to or greater than
the trigger set number shown in the following table.
Bit 7: RTRG1 Bit 6: RTRG0
0 0
1
1 0
1
Rev. 6.0, 07/02, page 676 of 986
RTS2 Output Active Trigger (RSTRG2, RSTG1, and
RTS2 RTS2
Bit 8: RSTRG0
0
1
0
1
0
1
0
1
Receive Trigger Number
1
4
8
14
RTS2 Output Active Trigger RTS2 RTS2 RTS2
15
1
4
6
8
10
12
14
(Initial value)
(Initial value)