Fitting The Connector - ABB IRC5 Compact Product Manual

2.6.6 Fitting the connector

General
This section describes how to manufacture a cable for connecting the mains power
to the controller.
Specifications
The following describes the cable and fuse requirements for the mains power
connection to the IRC5 Compact controller.
Component
Cable type
Cable area
Fuse
Included parts
The following parts are included in the delivery.
Part
Hood
Female insert
Cable gland
Procedure
Use the following procedure to fit the connectors.
1
2
3HAC035738-001 Revision: E
Description
Flexible oil resistant rubber
3 x 2.5 mm
Delay action fuse 10A
Recommended supplier
Harting
Harting
Harting
Action
Select a suitable single phase cable and earth cable,
and cut it to desired length.
Fit the cable through the cable gland and hood.
© Copyright 2009-2013 ABB. All rights reserved.
2 Installation and commissioning
2.6.6 Fitting the connector
2
Order number
19 20 003 1440
09 12 005 2733
19 00 000 5184
Note/illustration
See previous specifications.
xx0900000365
Qty
1
1
1
• A: hood
• B: female insert
• C: cable gland
Continues on next page
55