ABB IRC5 Compact Product Manual page 148

4 Repair
4.16.3 Replacement of line filter
Continued
3
4
5
6
7
8
Refitting
Use the following procedure to refit the line filter.
1
2
3
148
Action
Remove the left and right side covers
of the cabinet.
Lift the middle layer of the cabinet and
secure it.
Disconnect cable from L1 L2 L3 and L1'
L2' L3' connector of the filter.
Disconnect two of the filter earth cables
from the ground terminal.
Remove the four attachment screws of
the line filter.
Pull out the line filter.
Action
DANGER
Before commencing any work inside the cabinet, please observe the safety information
in section DANGER - Make sure that the main power has been switched off! on page
Fit the line filter in position and secure the four attachment screws.
Reconnect all connectors disconnected during removal.
© Copyright 2009-2013 ABB. All rights reserved.
Note/illustration
See Removing the left side cover on page 67
and Removing the right side cover on
page 68.
See Lifting the middle layer on page
xx0900000572
• A: attachment screws for the line filter
3HAC035738-001 Revision: E
69.
29.