Fitting The Connector - ABB IRC5 Product Manual

2.5.8. Fitting the connector

General
This section details how to fabricate a cable for connecting the mains power to the Drive
Module.
Specifications
The following details the cable and fuse requirements for the mains power connection to the
Drive Module.
Component
Cable typ
Cable area
Fuse
Included parts
The following parts are included in the delivery.
Part
Female contact
Contact housing
Brass cable clamp with gasket
Procedure
The following details how to fit the connectors
3HAC021313-001 Revision: K
Description
Flexible oil resistant rubber
4 x 6mm2
Delay action fuse 25A
Action
1. Select a suitable three phase + earth cable and cut
it to desired lenght.
2. Make sure all parts required are available.
2 Installation and Commissioning, IRC5
Note/Illustration
See specifications above.
Specified in Included parts above.
2.5.8. Fitting the connector
Qty
1
1
1
Continues on next page
65