2.5.6. Connecting power supply to the Dual Cabinet Controller
General
The following sections details how to connect power supply to the Dual Cabinet Controller
for both the Control Module and the Drive Module.
Location
B
xx0400000758
A
B
To Control Module
Normally the 230 V cable between the Drive Module and the Drive Module is connected at
delivery.
The following procedure describes exceptions from the standard delivery, when the cable
must be connected to the Control Module after delivery.
3HAC021313-001 Revision: K
2.5.6. Connecting power supply to the Dual Cabinet Controller
Harness-230V from Drive Module to Control Module.
Cable gland for Harness-230V.
Action
1. Lead the harness through the
cable gland, into the Control
Cabinet.
2 Installation and Commissioning, IRC5
A
Note/Illustrator
Connectors on the Control Module are described in
section,
Connectors on controller, IRC5 on page 47
Continues on next page
61