Installation Of Interfaces In The Dual Cabinet; Requirements Safety Relay - ABB IRC5 Product Manual

Installation of interfaces in the Dual Cabinet

Requirements safety relay

The safety loop demands a safety relay, it is not included in the upgrade kit and has to be
supplied by the customer.
Relay specification:
3HAC021313-001 Revision: K
2.9.8. Upgrading and installation of 2X Euromap interface (Option 671-4)
Action
8. Connect the harness from the
panel board to the adapter.
9. Connect the safety relay.
Action
1.
DANGER!
Before any work inside the
cabinet, please observe the
safety information in section
DANGER - Make sure that the
main power has been switched
off! on page 28.
2.
esd
WARNING!
The unit is sensitive to ESD,
before handling the unit please
observe the safety information
in section WARNING - The unit
is sensitive to ESD! on page 29
3. Install harness 2 and the
adapter 3HAC032370-001.
4. Connect the safety relay.
• Two channels
•
Six NO contacts
2 Installation and Commissioning, IRC5
Note/Illustration
Connectors X13.1, X13.2 and X13.3, described in
section Adapter Euromap 67 on page
Described in section Installation of safety relay on page
136.
Note/Illustration
Described in step 1-8 in section
interfaces in the Single Cabinet Controller on page
133.
Described in section Installation of safety relay on
page 136.
Continued
137.
Installation of
Continues on next page
135