ABB IRC5 Product Manual page 273

4.19. Replacement of hard disk or IDE Flash module and cable in computer unit DSQC623
3HAC021313-001 Revision: K
Action
5. Reconnect the flat ribbon cable to the primary
IDE connector on the motherboard.
6.
Note
Make sure the drive to be used is defined as
"Master".
7. Push the cage back in to the computer unit, and
secure it with the attachment screws.
8. Make sure no cable is damaged, and close the
computer unit
4 Repair activities, controller IRC5
Note/Illustration
xx0400000895
• A: Primary IDE connector
The jumper delivered with the IDE
flash module from ABB
(3HAC020988-008), shall not be
used.
Shown in the figure in section
Location.
Detailed in section
motherboard in computer unit
DSQC623 on page
Continued
Replacement of
230.
271