Connecting Power Supply To The Single Cabinet Controller; Connection Through A Cable Gland - ABB IRC5 Product Manual

2 Installation and Commissioning, IRC5

2.5.5. Connecting power supply to the Single Cabinet Controller

2.5.5. Connecting power supply to the Single Cabinet Controller
General
The following sections details how to connect power supply to the Single Cabinet Controller.
Location
A
xx0500001869
A
Prerequisites
Power supply cable (3-phase)
External earth fault protection at control cables 3 -15m
External earth fault protection at control cables >15m
Standard toolkit
Other tools and procedures may be required. See
references to these procedures in the step-by-step
instructions below.
Circuit Diagram

Connection through a cable gland

The following procedures detail how to connect the mains power to the controller through a
cable gland.
58
Cable gland
Equipment
Action
1. Connect power supply from an external
earth fault protection.
Note
30mA
300mA
The contents are defined in
section Standard toolkit!
These procedures include
references to the tools required.
See Circuit Diagram on page 341
Note/Illustration
Described in section, Prerequisites
Continues on next page
3HAC021313-001 Revision: K