Connection Through A Connector - ABB IRC5 Product Manual

2 Installation and Commissioning, IRC5
2.5.5. Connecting power supply to the Single Cabinet Controller
Continued

Connection through a connector

The following procedures detail how to connect the mains power to the controller through a
connector.
NOTE!
To fabricate a cable with connector is described in section
60
Action
5. Route the phase wires through the pipe
up to the rotary switch.
6. Connect the wires as shown in the illus-
tration.
Action
1. Connect the power cable from the shop
supply to connector XP0 on the front panel
on the controller.
Note/Illustration
See illustration above.
xx0500001882
Fitting the connector on page 65
Note/illustration
xx0500001852
Parts:
• A: XP0 Mains power connector
3HAC021313-001 Revision: K