Procedure Ide Flash Module - ABB IRC5 Product Manual

Procedure IDE flash module

The following procedure details how to install a Solid State Drive.
3HAC021313-001 Revision: K
2.9.6. Installation of extra mass memory in computer unit DSQC623
Action
7. Disconnect the flat ribbon cable from the
IDE connector on the motherboard.
8. Connect the included flat ribbon cable to the
IDE connector on the motherboard.
9. Reconnect the flat ribbon cable to the mass
memory units.
10. Make sure if the drives are to be defined as
"Master".
11. Push the cage back in to the computer unit,
and secure it with the attachment screws.
12. Make sure no cable is damaged, and close
the computer unit.
Action
1.
DANGER!
Before any work inside the cabinet, please
observe the safety information in section
DANGER - Make sure that the main power has
been switched off! on page
2 Installation and Commissioning, IRC5
Info/Illustration
xx0400000895
• A: IDE connector
xx0400000941
• A: Hard disk, solid state drive
• B: Flat ribbon cable connection, 40
pin
How to define the unit is shown on a
sticker on the unit.
Detailed in section
motherboard in computer unit DSQC623
on page 230.
Note/illustration
28.
Continued
Replacement of
Continues on next page
121