Connection Of Servo Disconnect, By Servo Power Switch - ABB IRC5 Product Manual

2 Installation and Commissioning, IRC5

2.5.14. Connection of servo disconnect, by servo power switch

2.5.14. Connection of servo disconnect, by servo power switch
General
The IRC5 controller is pre-wired to accept a customer servo disconnect.
NOTE!
Due to risk of voltage drop, the switch to the servo disconnect circuit should not be mounted
more than 50 meters from the Drive Module.
Location
The contactor is found on the left hand side inside the Drive Module as shown below.
xx0400001058
A
B
C
D
E
Required equipment
The table below details the required equipment.
Equipment
Wire
Switch
Standard toolkit
Circuit Diagram
80
A
B
D
MOTOR ON contactor K42 / K43
Contactor block3
Brake contactor
Jumper (4 pcs)
Contactor interface board
C
E
Note
AWG 10, brake AWG 16
500V 40 A, brake 24V 10A
See Circuit Diagram on page 341
3HAC021313-001 Revision: K
Continues on next page