Advertisement
Configuration and Diagnostic Modes
CAUTION
2-10
Configuration and Diagnostic Modes
The instructions below describe how to enter Configuration Mode and Diag-
nostic Mode.
Configuration Mode
These instructions describe briefly how to enter Configuration Mode. See the
Instructions for Use for details on configuration settings and what effect they
have.
Inserting or removing the Data Card while the unit is on can corrupt the Data
Card and prevent the unit from powering on again. If this occurs, see Chapter
3, Troubleshooting.
1. Power off.
Make sure the unit's power is off.
2. Insert the Data Card.
If you intend to save the configuration to a Data Card (or load the config-
uration from a Data Card), insert the Data Card now. To avoid possible
confusion, designate one Data Card as the "Configuration Card" and label
it clearly. Keep this card physically separate from cards used by the clini-
cal staff for data storage.
3. Enter Configuration Mode.
Press softkeys 4 and 5 at the same time, and hold them down while turn-
ing the power on. See Figure 2-1 for softkey numbering.
4. Select and manage Configuration choices.
To select a configuration, press the
or down the list until the desired Settings item is highlighted. Then
press the
ENTER
To print out a strip with all the current configuration choices, select
Print All Settings and press
To store the configuration settings on a data card, select Save Settings
to Data Card and press
Data Card? press
To load configuration settings from a Data Card, select Load Settings
from Data Card and press
from Data Card? press
5. Exit Configuration Mode.
To exit Configuration Mode, turn the unit off.
Wait 2 seconds. Remove the Data Card by pressing the black eject
button and pulling the Data Card from the compartment.
and
softkey to access those settings.
.
ENTER
. When prompted with Save Settings to
ENTER
.
SAVE
. When prompted with Load Settings
ENTER
.
LOAD
Performance Verification and Safety Tests
softkeys to move up
Advertisement
