Advertisement
M3500B/M5500B Service Manual
Tool Requirements
The following tools are needed to perform the procedures given.
Torx T10 and T15 drivers (or Torx driver kit, Philips part number
5181-1933). T15 driver shaft should be at least 2.25" long and less
than 5/16" in diameter to reach down to recessed case screws.
Phillips #1 screwdriver.
Small straight bladed screwdriver.
Straight tip needle nose pliers or tweezers.
Bent tip needle nose pliers whose jaws are covered with a soft mate-
rial (such as plastic tubing or tape).
Fine nose wire cutters.
Utility knife.
High voltage discharge tool for discharging the defibrillator capacitor
(Philips part number M2475-69572).
Clip leads (at least 2, each approx. 10-18").
Language Support Tool (see Table 5-2 on page 5-7 part numbers)
Tool Requirements
4
4-3
Advertisement
