Exporting Data - Huawei NetCol8000-C070 User Manual

NetCol8000-C(070, 130, 190) In-room Chilled Water
Smart Cooling Product
User Manual
●
Step 2 Disconnectthe main power supply from the smart cooling product.
Step 3 Contact Huawei technical support to replace the backplane of the smart cooling
product.
----End

7.1.17 Exporting Data

Context
With the one-click mode, you can export active alarms, historical alarms, run logs,
and so on.
You are advised to use the FAT32 USB flash drive with a capacity no greater than
64 GB. Format the non-FAT32 USB flash drives into FAT32 ones before using them.
Before using a USB flash drive, ensure that its data has been scanned by antivirus
software and is secure.
Procedure
Step 1 Tap Maint > USB Operations > Export to enter the Select Path screen, as shown
in Figure
Figure 7-13 Select path
Step 2 Tap the file where the user saves current data in the Select Path dialog box and
tap Next. Then tap Yes in the displayed dialog box.
Issue 02 (2020-08-30)
If no, continue with Step
NO TICE
NO TE
● Before exporting active alarms, historical alarms, logs, and configurations, ensure that
the USB flash drive has been successfully identified. The USB port is located on the side
of the main control board.
● If the USB flash drive has been successfully identified,
● If the USB flash drive is not properly connected, the system will display No USB device
found. during operations about the USB flash drive.
7-13.
Copyright © Huawei Technologies Co., Ltd.
2.
7 FAQ
is displayed in the status bar.
194