Toshiba H1 Series Data Book page 41

(3) Operation
a. IDLE2 Mode
In IDLE2 Mode, only specific internal I/O operations, as designated by the
IDLE2 Setting Register, can take place. Instruction execution by the CPU stops.
Figure 3.3.8 illustrates an example of the timing for clearance of the IDLE2
Mode Halt state by an interrupt.
X1
A0~A23
D0~D31
RD
WR
Interrupt for
releasing Halt
Figure 3.3.8 Timing chart for IDLE2 Mode Halt state cleared by interrupt
b. IDLE1 Mode
In IDLE1 Mode, only the internal oscillator and the RTC and MLD continue to
operate. The system clock stops.
In the Halt state, the interrupt request is sampled asynchronously with the
system clock; however, clearance of the Halt state (i.e. restart of operation) is
synchronous with it.
Figure 3.3.9 illustrates the timing for clearance of the IDLE1 Mode Halt state by
an interrupt.
X1
A0~A23
D0~D31
RD
WR
Interrupt for
releasing Halt
Figure 3.3.9 Timing chart for IDLE1 Mode Halt state cleared by interrupt
Data
IDLE2
mode
Data
IDLE1
mode
92CZ26A-38
TMP92CZ26A
Data
Data