Commissioning of the KNX Function via DCA (from ETS5)
Notice
■
■
■
1.1.2
KNXnet/IP Secure
Availability of KNXnet/IP Secure
For secure IP communication, the KNX IP interface is extended by the KNXnet/IP Secure
standard. Through the optional use of KNXnet/IP Secure, all incoming and outgoing telegrams
and data are fully encrypted. By default, KNX IP Secure is always deactivated in the factory
settings of the IP touch.
Notice
■
From which firmware version KNX and KNXnet/IP Secure is available depends on the panel
used:
IP Touch 7
IP touch 10
Product manual 2CKA001473B5023
Use a card that corresponds to the SDHC standard. Some cards may not
function correctly.
–
It is recommended to use SDHC cards from ScanDisk, Kingston and
Transcend that have been fully tested and checked.
While pictures are being recorded or copied on the card, do not remove the
SD card nor restart the panel. Otherwise, pictures may not be displayed.
ABB is not liable for the performance of an SDHC card.
In the ETS or DCA, the IP touch is always integrated into one of the TP lines
with the media type "TP". This happens regardless of whether KNXnet/IP
Secure is activated or deactivated in the IP touch.
This is due to the fact that the IP touch establishes a tunnelling
–
connection and the media type TP must be set for this purpose.
–
KNXnet/IP Secure is always deactivated on the ETS/IP backbone.
From version 1.70
From version 2.10
│12