Control Actions Of Additional Applications; Presence Simulation - ABB IP Touch 7 Manual

4.5

Control actions of additional applications

4.5.1

Presence simulation

The absence of the residents in a building can be fairly realistically simulated via the presence
simulation, to increase the protection against unauthorized access. For this purpose the Busch-
SmartTouch ® 7'' specifically records all actions for up to 20 objects every minute of the whole
day (up to 0 o'clock) and can then replay them again.
Note
–
–
–
The presence simulation application is called up as follows:
1. Swipe to the right on the main operating page (homepage).
– The application page with applications and system settings opens.
2. Tap on "Timer".
3. Select presence simulation in the list.
This starts the application. The icon for the activated presence simulation is displayed.
The presence simulation application is deactivated up as follows:
1. Tap on the activated presence simulation in the list.
Product manual 2CKA001473B5023
Please note that you must always create a presence simulation beforehand,
so that the simulation can be played back later!
For this the device must have been active once for at least one day (up to 0
o'clock) and have recorded telegrams (per minute). Otherwise the message
that no data are available is displayed at the start of the application.
The application always uses the telegrams of the previous day. If no data are
available on the previous day, the data of days before the previous day are
used.
Operation
│209