Network Settings; Installation Of The Ip Touch Ets App - ABB IP Touch 7 Manual

Commissioning of the KNX Function via DCA (from ETS5)
1.1.4

Network settings

To use the KNX IP interface, the network settings must be changed. To do this, enter the IP
address of the KNX IP interface in the IP touch.
KNX IP interfaces should always have a fixed IP address. This can either be a static
■
address or a fixed DHCP address.
The IP touch used must be in the same IP address range as the KNX IP interface.
■
Notice
When using a router or level 3 switch, no separate port release is required. If
VLAN is used on a router or level 3 switch, please ensure that IP touch and
IPS/S are in a common VLAN.
1.1.5

Installation of the IP touch ETS app

For the assembly of the control elements, the initial commissioning of the IP touch and for the
display of the DCA commissioning tool, a special app must be installed.
This app can then be called up in the ETS via an additional tab (DCA). For this a licensed
version of the ETS Professional Software must be installed on the target computer for the
installation. At least Version ETS5 is required.
Notice
■
■
■
Product manual 2CKA001473B5023
The app for the ETS5 can be downloaded via the electronic catalogue
(www.busch-jaeger-catalogue.com).
The app for the ETS5 can also be downloaded directly via the homepage of
the KNX organisation (https://knx.org).
The apps are called up on the start page of the ETS via "App" (bottom right).
│14