Commissioning Sequence; Configuring Basic Settings For The Panel - ABB IP Touch 7 Manual

Commissioning of the KNX Function via DCA (from ETS5)
1.5

Commissioning sequence

To be able to work with the DCA commissioning tool as effectively as possible, the following
work sequence (standard workflow) is recommended:
1. Start the ETS software (see chapter 1.2.1 "Starting the DCA" on page 17).
2. Create a new project or open an existing one.
3. Open the configuration surface via the DCA tab.
4. Configure basic settings for the touchdisplay.
5. Create the navigation structure (see chapter 1.7 "Creation of the navigation structure" on
page 26).
6. Configure the operating pages (insert and configure control elements).
7. Configure the applications and application pages.
8. Edit the available communication objects.
9. Create group addresses and allocate the correct data point type (DPT) to all group
addresses used in the device (e.g. function: 1.001 switch).
10. Copy the project to an SD card and transmit it locally onto the IP touch.
– A detailed description of the DCA export procedure is available in Chapter 1.13.1
"Import" on page 44.
1.6

Configuring basic settings for the panel

The basic settings for the IP touch can be specified beforehand.
1. Open the "Applications" tab in the library area.
2. Open "System settings".
– The basic settings are displayed in the "Parameter" area and can be edited (see chapter
1.6.1 "Basic settings (system settings) of the panel" on page 23).
– Available communication objects for certain functions are displayed in the
"Communication objects" area and can be used.
– Group addresses can be allocated via the "Group addresses" area.
Notice
Some basic settings can only be adjusted directly in the panel, e.g. the panel
language, PIN code level, etc..
Product manual 2CKA001473B5023 │22