Basic Information - ABB IP Touch 7 Manual

6.2

Basic information

Please note the following information.
Assignment of the IP addresses
There are two different options for assigning IP addresses.
Assignment of static IP addresses
The IP addresses are assigned directly in IP touch
or for the KNX IP interface via the ETS.
When using statically assigned IP addresses, the
Welcome app and an additional extension
(IP touch) cannot be used.
When assigning new static and dynamic IP addresses, each new IP address must be entered in the
IP touch.
Notice
KNX integration is not possible via the LAN1 connection. For KNX integration,
use the LAN2 connection or the WLAN connection of the IP touch. A router is
mandatory when using a WLAN connection.
Subsequent router connection
Proceed as follows if you wish to connect a route subsequently:
1. Change the IP touch from static IP address assignment to DHCP mode.
2. Switch the IP interface from static IP address assignment to DHCP mode (in the ETS).
3. Enter the new IP address of the IP interface into the IP touch.
Notice
If a router is used as an option, fixed DHCP addresses for the IP touch and the
IP interface should be assigned in the router.
Product manual 2CKA001473B5023
Assignment of dynamic IP addresses
The IP addresses are assigned via a local router
(both the KNX IP interface and IP touch must be
in DHCP mode).
When using dynamic IP addresses, the Welcome
app and an additional extension (IP touch) cannot
be used.
The second extension (IP touch) must be in
■
the same address range as the master unit.
Case studies
│223