Application "Fault And Alarm Messages - ABB IP Touch 7 Manual

Commissioning of the KNX Function via DCA (from ETS5)
1.10.2

Application "Fault and alarm messages"

This application has an application page on which the issued messages are displayed. The
individual messages are also displayed directly in the panel according to the configuration.
Messages can be created, activated and configured via the DCA.
1. Open the "Applications" tab in the library area.
2. Open "Fault and alarm messages".
3. In the "Parameter" area use, activate the application via "Fault and alarm messages".
– In the "Parameters" area, the general settings for the application page and messages
are displayed. They can be edited here.
– All messages are listed in the application page. The special specifications for the
individual messages can be made separately for each message.
Notice
Individual fault and alarm messages can be created. These can also be added
via the work area.
–
–
–
For further setting/selection options via the "Parameter" area for the general settings of the
■
application page, see chapter 2.15 "Application "Fault and alarm messages" - Global
settings" on page 116.
For further setting/selection options via the "Parameter" area for the settings of the
■
individual message, see chapter 2.16 "Application "Fault and alarm messages" - Settings of
the individual messages" on page 119
Product manual 2CKA001473B5023
Here a page with a plus is displayed. This page must be clicked. This is how
a further fault and alarm message is added and displayed in the tree
structure.
If it is called up via the tree structure, the settings can be adjusted for the
individual message in the "Parameter" area.
By clicking the arrow next to "Fault and alarm messages", all available
messages are displayed.
│37