ABB IP Touch 7 Manual page 216

Note
The correct coordinates of the device location must be set for the astro function.
–
7. Tap on "Create".
– The time program is then taken up into the time program list and can be edited there.
8. Finally tap on "OK".
– A time program icon appears next to the control element with a digit (number of created
time programs with this control element).
Note
For this, however, one must tap on the pen icon on the operating page.
Modification of time programmes
1. Tap on the pen icon.
2. Then in the list, tap on the arrow next to the time program that is to be edited.
3. The editing view for this time program opens.
Fig. 25: Editing view of time program
Editing options:
Adjustment of function (e.g. switch on or off).
■
– Use the arrow for the selection.
Adjust the time.
■
– Tap on the weekday. Then the time setting opens again.
Specify the execution (always; on holiday; not on holiday).
■
– Use the arrow for the selection.
Deactivation/activation of the time program.
■
– Use the slider.
– The adjustments become active immediately.
Product manual 2CKA001473B5023
This is carried out via the system settings of the commissioning tool (DCA).
Operation
│216