ABB IP Touch 7 Manual page 120

Application "Fault and alarm messages" - Settings of the individual messages
Repeat of alarm as long as it is active:
Options:
– Deactivated: In the active state the acoustic alarm signal is not repeated. No additional
parameters available.
– Activated: The signal tone is repeated as long as the alarm is active. The following
supplementary parameter is available:
Repeat time [min.]:
Options:
The parameter is used to specify the cycle (in minutes) with which the alarm is repeated.
– 14 byte: A text is displayed and sent when acknowledging the alarm. The following
supplementary parameters are available:
Sending text at acknowledgement:
Options:
– Deactivated: No text is sent at acknowledgement. No additional parameters available.
– Activated: The text that was specified via the following parameters is sent at
acknowledgement:
Text at acknowledgement:
Options:
The parameter is used to specify the text that is sent at acknowledgement of the alarm.
The length of the text is limited to 60 characters.
Acoustic alarm signal:
Options:
The parameter is used to specify whether the signal tone specified under the global settings
is played .
– Deactivated: No acoustic alarm signal. No additional parameters available.
– Activated: The signal tone is played at an alarm signal. The following supplementary
parameter is available:
Duration of audio signal [min.]:
Options:
The parameter is used to specify how long the specified signal tone is to be played (in
minutes).
Product manual 2CKA001473B5023
Control elements and application parameter
Deactivated
Activated
Setting option from 1 - 60
Deactivated
Activated
<Text>
Deactivated
Activated
Setting option from 1 - 60
│120