Lifting With Rotating Eyebolts - ABB ACS5000 User Manual

4.5.3. Lifting with rotating eyebolts

Rotating eyebolts are either installed in the factory or are in the loose parts box for the drive.
The following procedure requires a crane with a lift frame or a spreader frame.
1. For rotating eyebolts (1) from the loose parts
box, use the attached star key (2) to hand-
tighten and properly seat the mounting bolt
(3).
CAUTION! DO NOT use an extension with the
star key tool. Remove the star key (4) before
you attach the lifting gear. The eyebolt must
be able to rotate 360° when mounted.
2. Rotate the eyebolts (1) in the pull direction
(3), ie, sling direction, and then attach slings
to the eyebolts with safety hooks or shackles
(2).
CAUTION! DO NOT run slings through the
eyebolts!
Referring to Fig. 33, page 63:
3. Protect the edges and other protrusions on the load from direct contact with the lifting
gear, eg slings.
4. Lift the load slowly and steadily, with no abrupt stops, in an upright position to the
required clearance height.
CAUTION! Keep an eye on the horizontal position of the load and reposition the slings when
necessary.
5. At the end of the lifting operation, remove the hand-tightened eyebolts that you installed in
step 1.
NOTE – For a permanent installation, tighten the eyebolts to the correct torque (see
Section 4.5.4, "Reinstalling lifting attachments", page 62) with a suitable torque wrench
socket (not included in the scope of delivery).
PRODUCT
ACS5000W gen. 2
DOCUMENT KIND
User manual
TRANSPORTATION, STORAGE, AND DISPOSAL
1
2
3
2
1
DOCUMENT ID.
3BHS799208 E01
4
360°
3
REV. LANG. PAGE
J en 61/186