Selecting The Actual Signals Display - ABB ACS5000 User Manual

9.2.2.1.1. Actual values
For the complete list of selectable actual signals, see "Appendix G – Signal and
parameter table".
The actual values are organized in groups.
Group Description
Group 01 Measured or calculated motor values
Group 02 Measured or calculated drive values
Group 03 Reference values
Group 04 Status signals of S800 I/O system
Group 05 Communication link and MCB status signals
Group 06 Software version, drive and motor nominal values
Group 07 Control words
Group 08 Status words
Group 09 Fault and alarm words
9.2.2.1.2. Fault memory
The fault memory display provides information on the 64 most recent fault events that occurred
in the drive. It displays the name of the fault and the time it occurred. For instructions on how
to display and reset the fault memory, see Section 9.2.2.7, "Displaying and resetting an active
fault", page 146.
When the drive generates a fault or alarm, the corresponding message displays immediately.
Changing from the fault memory display to other modes is possible without resetting the fault
first. If no key is actuated, the fault or alarm message displays as long as the fault is active.

9.2.2.2. Selecting the actual signals display

To select the actual signals display, press the ACT key.
ACT
PRODUCT
ACS5000W gen. 2
1 L -> 600.0 rpm
StateINU ReadyOn
MOTOR SP 0.00 rpm
POWER 0.0 kW
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS799208 E01
CDP CONTROL PANEL
REV. LANG. PAGE
J en 142/186